Other Snapshot Commands
These commands are available by right-clicking in different snapshot configuration columns.

Commands are listed from left to right and from top to bottom as shown in the diagram above.

Delete Snapshot Set:. Deletes an existing Snapshot Set.

Reset Snapshot Set: The Reset command deletes all Snapshot Images under a Snapshot Set.

Snapshot Set Host LUN Mapping: Associates a Snapshot Set with a host ID/LUN combination. Mapping a Snapshot Set equals mapping a Source Volume. If the Source Volume has previously been mapped to a host ID/LUN, the corresponding Snapshot Set may be mapped to another host ID/LUN.

Create Snapshot Container: The creation process is described in Create Snapshots.

Expand Snapshot Container: This command allows you to expand an existing Snapshot Container by adding another RAID partition.

Delete Snapshot Container: Deletes an existing Snapshot Container.

Create Snapshot Set: Creates another Snapshot Set under a Snapshot Container.

Fault recovery commands: The Fault recovery commands apply only when system faults occur. For some reasons, the snapshot cannot write to disks, or fail to read data from Snapshot Containers or Sets. The fault recovery commands can be used to recover the inconsistencies after hardware or media faults are corrected.

Delete Snapshot Image:. Deletes an existing Snapshot Image.

Snapshot Image Host LUN Mapping: Mapping a Snapshot Image to host ID/LUNs enables users to retrieve data in Source Volume at its T0 state. The mapped image is read-only.

Back to Help Contents