Email

Receiver Side
To set an Email Address to be receiving notification emails:

Step 1: Find the Email settings by clicking the Email icon on the top screen menu bar.

Step 2. Right-click on the lower half of the configuration screen to display the add recipient prompt.



Step 3: An Add recipient prompt displays. Click "Add" to display another prompt and then enter the address for email notification.



Step 4: Select the severity level of events to be sent to the receiver's email. Notifiation means all levels of events will be sent. Critical means only the critical events will be delivered.

Step 5: Repeat this process to add more email addresses.

You may also edit an existing recipient by double-clicking on a recipient entry.

Sender Side
From the Module Config window:
Step 1: Find the Email settings by clicking the Email icon on the top screen menu bar.

Step 2: Click the On/Off switch on the upper right corner of the SANWatch screen to enable Email notification.

Switched ON	Switched OFF

Step 3: Set Status to Enable if you want the module to be activated every time the Notification Manager (namely, the SANWatch management center is started) is started. Note that the On/Off switch should also be in the ON position before you turned off the server or closed the utility. Otherwise, you will have to manually enable the function again.

Step 4: Select the Severity level of events to be sent to the receiver station.

Step 5: Enter the Mail subject by double-clicking the Current Value field; e.g., "events from RAID group B."

Step 6: Set your SMTP mail server

Setp 7: Enter Account name or Password if your mail server requires these two values.

Step 8: Provide a valid Email address as your Sender's Address


Back to Notification Manager page

Back to Help Contents